Revox Re:source MMM - Manual (Page 13)

Multi Media Re:source
12
S
ETUP
Multi Media Module
The basic settings for the MMM are
made in Setup.
Select Media from the
Source
menu and press and hold the
Setup key for approx 2 seconds.
Then select the Source softkey.
The following display appears:
All settings that are needed to set
the MMM up are done on a total of
eleven Setup pages, whereby only
the relevant pages are shown.
Setup pages that you don't need
because of a setting you have
made are hidden.
Example: Setup #6
Use DHCP? YES
By selecting YES the settings on
#7 and #8 in the IP and DNS area
respectively are automatically
made by the MMM. These Setup
pages therefore, are not shown.
You switch directly from Setup #6
to Setup #9.
Important advice
The following description for the
Setup makes the assumption that
there is a functioning network with
router available and operational.
There is no further explanation of
the specialist terminology used in
the individual chapters. You will find
an extensive description of these in
the previous chapter "Glossary
N
ETWORK TERMINOLOGY
"
If you have any questions about the
setup and configuration of your
network or Internet access, please
refer to your System administrator
or an IT specialist of your choosing.
Input field in Setup [...]
Whenever you can make a setting
within an input field in the following
chapters, the area that is to be
changed appears in the display in
two square brackets [...].
M51 Inputs at the M51 are
made using the rotary knob. At
the same time, the small red lamp
(Jog) next to the rotary knob lights
up.
M10 Inputs at the M10 are
made through the display panels
from the M230 or M233 service
programs. In the case, you use the
fields Jog ±.