Revox Re:source MMM - Manual (Page 5)

Multi Media Re:source
4
I
NSTALLATION
The Multi Media Module is equipped
with the latest electronics and
should be handled with care.
Before you install the card, the M51/
M10 must be switched off and
separated from the power supply,
by plugging the unit out.
M51 Installation .
The MMM can be operated in slots
1 - 6. The only exception is Slot 7,
next to the speaker connections, as
this is reserved for the 5.1 Decoder
module.
For loading reasons, only one
MMM should be installed in an
M51.
M10 Installation .
The MMM can be operated in slots
1 - 8 or A 1 - 2. Slots A1 and A2
should only be fitted with second
generation modules, like the MMM,
that have the following symbol on
them:
Up to 4 MMMs can be installed in
parallel in an M10.
Loosen the two screws with the
TORX screwdriver supplied and
remove the blanking plate.
Before removing the MMM module
from its packaging, you should
make sure that you are not
statically charged. This could cause
a damaging discharge of voltage
when you touch the module. You
should get rid of any static charge
by touching an earthed metal
object like a radiator, for example.
Remove the MMM from its
packaging and feed it into its plug-
in position. The two bars inside the
M51/ M10 are the mechanical
guides for you to use.
The lettering on the MMM plug-in
card must be on top. Shortly before
the plug-in card is fully locked into
position in its slot, you will feel a
mechanical resistance, caused by
the bus board contact strip. Push
the MMM fully in by applying
pressure in the area of the two
screw holes and fix the card in
place with both screws.
All further steps for registering the
new module are carried out
automatically the next time you
switch on.
G²
!
!