Revox Re:source MMM - Manual (Page 36)

Multi Media Re:source
35
Synchronising MyMusic
The following display appears the
first time the MMM is started on the
remote control:
The MyMusic selection has not yet
been synchronised in this
constellation.
Connect the M208 with the supplied
USB cable to the M208 Link inter-
face for synchronisation. The Link
interface for its part is connected to
the M10 / M51 through a cable to
the M Link.
Once the connection is established,
select the source key at the M208
where the MMM controller is stored
and press the SETUP key. Confirm
the setting
 Synchronize with the
OK key.
Important advice
The M208 remote control must not
be operated while synchronisation
is running.
Synchronisation now starts and
only takes a few seconds. When
the synchronisation is complete,
the following display appears:
Now, all stored MyMusic entries
appear in the display the next time
the MMM controller is called. The
display order is determined by the
order they were stored in the
MMM.
L
A synchronisation with the M208
should always be carried out if you
modify any of the MyMusic entries
in the MMM by adding new ones or
deleting existing ones. Otherwise,
wrong MyMusic entries will be
called.