RCA ProV600 - Manual (Page 13)

First-Time Operation
11
Using the Adapter/Charger to Power Your Camcorder
The adapter/charger attaches to the camcorder and lets you power your camcorder
directly from standard household power. The adapter/charger operates on 100-240
volts, 50/60 Hz, so it can be used virtually anywhere in the world to power the
camcorder or recharge the battery.
Attach Adapter/Charger
1. Connect one end of the DC cable to
the DC OUT jack on the adapter/
charger.
2. Press the OPEN button and open the
LCD monitor.
3. Connect the other end of the DC cable
to the DC IN jack on the camcorder
and run the cable through the cutout
as shown.
4. If the adapter/charger is properly
connected, its POWER indicator
will light.
Caution: Do not use this adapter/
charger for any other purpose other
than charging the AV55 battery
pack or supplying power to
the camcorder.
Remove Adapter/Charger
1. Unplug the adapter/charger from the
wall outlet.
2. Remove the DC cable from the
adapter/charger and camcorder.
3. Close the LCD monitor and press on it
gently until it locks into place.
Using an Optional Plug Adapter
An optional plug adapter may be required
in some countries.
1. Plug the adapter/charger’s plug into
the AC plug adapter.
2. Plug the AC plug adapter into the AC
outlet.
AC 100-240V
Optional AC
Plug Adapter
POWER
Indicator
DC IN Jack
DC Cable
Adapter/
Charger
To AC
100-240,
50/60 Hz
DC OUT
Jack
OPEN
Button