RCA ProV600 - Manual (Page 14)

12
First-Time Operation
Using the Battery to Power Your Camcorder
The battery must be charged as described on the next page before it can be used the
first time. Initial charging will take approximately 60 minutes. When fully charged,
the battery should supply about 50 minutes of operating time (depending on how much
you use zoom and pause). Conserve battery power by turning the camcorder off during
recording breaks.
Note: The small marker switch on top of the battery is for use as a personal reminder to help you
recharge the battery. It has no other function.
Attach the Charged Battery
Remove the DC cable if attached.
1. Press the OPEN button to open the
LCD monitor. Carefully open the
monitor fully.
2. Insert the battery sideways aligning
the marks on the battery compart-
ment and battery. Press on the
battery where shown while sliding it
up and locking it into place.
BATT (Battery
Release) Button
OPEN Button
Remove the Battery
1. Press the OPEN button to open the
LCD monitor. Carefully open the
monitor fully.
2. Press in the BATT (battery release)
button, slide the battery down, and
remove it.
3. Close the LCD monitor and press it
gently until it locks into place.
ATTENTION: The RBRC seal on the battery used in your Thomson
Consumer Electronics product indicates that we are participating in a
program to collect and recycle Nickel Cadmium batteries throughout the
United States. Please call 1-800-8-BATTERY for information or
contact your local recycling center.
Rechargeable
Battery (Press
here.)
Marker
Switch
Battery Safety Precau-
tions
Do not short the battery’s
terminals.
Do not attempt to disas-
semble or modify the
battery. There are no user-
serviceable parts inside.
Use the battery only with
specified adapter/chargers
and camcorders.
Throwing the battery into a
fire or exposing it to
excessive heat – over 149ºF
(65ºC) could be hazardous.
RBRC
RBRC
Ni-Cd