RCA ProV600 - Manual (Page 33)

31
Recording
Date/Time Display — Clock Lithium Cell
The clock cell indicator 88:88 will flash for a few seconds in the viewfinder
when you turn on the camcorder if the clock lithium cell has not been installed
or needs to be replaced.
Install the Clock Lithium Cell
1. Make sure camcorder is turned off,
and remove any power supply
attached to the camcorder.
2. Pull out the clock cell holder.
3. Insert the clock cell with the “+”
terminal facing up in the cell holder.
Cautions: Lithium cell battery. Replace only with 3-volt lithium cell – such
as CR2025. Use of other cell presents a risk of fire or explosion. Must be
disposed of properly. Never handle punctured or leaking cell. May cause
burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If
swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical
burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or
incinerate.
Never use metallic tweezers to hold the cell, and never short the + and – sides
of the cell.
Clock Cell Holder
Clock Cell (+ Side Facing Up)
4. Slide the clock cell holder with the
cell into the camcorder until it clicks
into place.
Remove the Cell
1. Slide the cell holder out of the
camcorder.
2. Remove the cell from the cell holder.