ResMed escape s8 - Manual (Page 25)

21 H OW TO U SE THE S TANDARD M ENU
E
NG
LI
SH
H
OW TO
U
SE THE
S
TANDARD
M
ENU
Figure 1 shows the standard menu.
Figure 1 : Standard menu screens: CPAP and AutoSet modes
You enter the standard menu from the standby (RAMP or SETTLING) screen, by
pressing the
Left (Menu) key.
H OW TO C HANGE THE E XPIRATORY P RESSURE R ELIEF S ETTING
Note: EPR may not be available in all regions.
In CPAP mode, your clinician may have set up your device to deliver expiratory
pressure relief (EPR). This can be used to help ease any discomfort you may
experience when breathing out during treatment. There are four settings:
•
OFF (no EPR)
•
1 (lowest EPR)
•
2
•
3 (highest EPR).
The EPR SETTING screen only appears if your clinician has enabled access to EPR
settings. To change the EPR setting, select Change (
Left key). Press the Up or Down
keys until you see the setting that you require.
H
OW TO S ELECT THE M ASK T YPE
Scroll to MASK and select Change ( Left key). Press the Up or Down keys until you
see the mask type that you require.
RAMP: 10min
menu
WELCOME
>>>>>>
SETTLING: 10min
menu
EPR SETTING: 0
change exit
CPAP WELCOME
>>>>>> AUTOSET
MASK: ULTRA
change exit
SW: SX3960200
exit
USED HRS: 08000
exit
USAGE: 1000/1068
exit
MASK: ULTRA
change exit
SW: SX3960200
exit
USED HRS: 08000
exit
USAGE: 1000/1068
exit