RadioLAN DockLINK - Manual (Page 13)

890-010 12/04/98 Page 5 © 1998 RadioLAN.
Quick Installation Steps
The RadioLAN DockLINK easily
attaches to your 10BaseT equipment
and puts it onto the wireless network.
Like other RadioLAN products, the
DockLINK is easy to install in just a
few steps.
1. Locate the DockLINK near to the
10BaseT device, like the printer in
Figure 3.
2. Attach an Ethernet cable between
the DockLINK 10BaseT port and
the device
3. Attach the radio assembly, and
locate it as high as practical, with
the two points upward
4. Apply power to the DockLINK, and
then power up the Ethernet device and you are done.
Radio Unit
Non-switched
Outlet
DockLINK
CAT5 Cable
Printer equipped
with 10BaseT network
interface card
Switched
Outlet
1
2
3
4
10BaseT
Figure 3: Quick Installation Steps