Ricoh 3245 - Manual (Page 31)

Canceling a Memory Transmission
23
2
Canceling a Memory Transmission
You can also cancel the mode using
the same procedure in the following
cases:
• Fax Destination, Internet Fax Des-
tination, and IP-Fax Destination
are specified simultaneously.
• Only either Internet Fax Destina-
tion or IP-Fax Destination is speci-
fied.
Before the Original Is Scanned
Use this procedure to cancel a trans-
mission before pressing the
{{{{Start}}}}
key.
AAAA
Press the
{{{{Clear Modes}}}} key.
Note
❒ When documents are placed in
the ADF, you can cancel trans-
mission simply by removing
them.
While the Original Is Being
Scanned
Use this procedure to cancel a trans-
mission after pressing the
{{{{Start}}}} key.
AAAA
Press the
{{{{Clear/Stop}}}} key.
The machine stops scanning.
Note
❒ You can also cancel scanning by
pressing [Stop Scanning].
❒ Scanning may be completed
while you are performing the
cancel operation.
While the Original Is Being
Transmitted
Note
❒ If the transmission finishes while
you are carrying out this proce-
dure, it will not be canceled.
❒ If you cancel a message while it is
being sent, the transmission is halt-
ed as soon as you finish the cancel-
lation procedure. However, some
pages of your message may have
already been sent and received at
the other end.
ZLBS050N
JupterC2_Fax_EN-F_FM.book Page 23 Tuesday, November 30, 2004 2:47 PM