Radio Shack PRO-94 - Manual (Page 25)

25 Operation
quency, then press PROG . The channel number
appears.
2. Use the number keys and • ( MON/CLR) to enter the
frequency (including the decimal point) you want to
store.
3. Press E ( SVC ) to store the frequency into the chan-
nel.
Notes:
• If you entered an invalid frequency in Step 2,
Error appears and the scanner beeps three
times. Enter a valid frequency.
• The scanner automatically rounds the entered
number to the nearest valid frequency. For exam-
ple, if you enter 151.473 (MHz), your scanner
accepts it as 151.475.
Press DELAY to pause scanning 2 seconds after the
end of a transmission before scanning proceeds to
the next channel (see “Delay” on Page 31). The
scanner stores this setting in the channel.
4. To program the next channel in sequence, press
PROG and repeat Steps 2 and 3.
SEARCHING FOR AND TEMPORARILY
STORING ACTIVE FREQUENCIES
If you do not have a reference to frequencies in your ar-
ea, use a limit, direct, or service search (except weather
service search) to find a transmission. Also see “Guide
to the Action Bands” on Page 59.
Note: While doing a limit, direct, or service bank search,
press:
• DELAY if you want the scanner to pause 2 seconds
after a transmission ends before it proceeds to the
next frequency (see “Delay” on Page 31).
• DATA if you want the scanner to skip data signals
(such as fax or modem signals) and search only for
20-524A.fm Page 25 Tuesday, June 27, 2000 3:41 PM