Radio Shack PRO-94 - Manual (Page 46)

46 Trunking Operation
To lock out an ID, press L-OUT (S/S) when the ID ap-
pears. The ID is locked out, and the next active ID ap-
pears.
Unlocking a Single Talk Group ID
1. Hold down L-OUT (S/S) until you hear two short
beeps.
2. Repeatedly press
8 8 8 8
or
9 9 9 9
to select the ID you
want to unlock.
3. Press L-OUT (S/S) . The ID is unlocked, and the
next locked ID appears.
4. Press SRC (LIMIT) to resume the scanner’s previ-
ously selected function.
Unlocking All Talk Group IDs
Hold down L-OUT (S/S) while searching until you hear
two short beeps, then press E (SVC) to unlock all the IDs
at once. The scanner beeps twice. Press L-OUT/SS to re-
sume the search.
Note: When you unlock all the IDs, the scan list appears.
Press
SCAN to scan the IDs stored in your scan lists or
press SRC (LIMIT) to resume the scanner’s previously se-
lected function. For more information about scan lists,
see “Using Talk Group ID Lists” on Page 48.
Using Trunk Scanning Scan Delay
Sometimes a user might pause before replying to a
transmission. You can set the scanner to hold on an ID
for 5 seconds to wait for a reply. That way, the scanner
continues to monitor the ID for 5 seconds after the trans-
mission stops before resuming scanning.
Press DELAY to turn trunk scanning scan delay on or off.
DLY appears when the scan delay is set to on.
Note: If you consistently miss responses even with scan
delay turned on, change the default system type or the
fleet map being used. See “Scanning Type I and Hybrid
Trunked Systems” on Page 51.
20-524A.fm Page 46 Tuesday, June 27, 2000 3:41 PM