Radio Shack PRO-94 - Manual (Page 50)

50 Trunking Operation
2. Select the ID scan list location where you want to
store the IDs, then press PROG . PGM appears.
3. Press MON/CLR . A monitor ID appears.
4. Press E . The scanner stores the IDs into the
selected ID scan list.
Scanning the Talk Group ID Lists
Press SCAN to begin scanning the lists you have stored.
Note: If one or more of the IDs you stored are incorrect,
Error flashes twice and the scanner beeps several
times, then the scan list numbers appear at the top of the
display. To correct the entry, delete at least one of the in-
correct IDs (see “Deleting a Stored Talk Group ID List”).
To remove a scan list from active scanning, use the
number keys to enter the scan list’s number. The scan
list number turns off, and the IDs in that list are not
scanned.
Note: One of the five scan lists must always be active.
You cannot remove all of them.
To restore a scan list to active scanning, use the number
keys to enter the number of the list again.
Press SRC to return to the previously selected function.
Deleting a Stored Talk Group ID List
1. Press PROG . PGM appears.
2. Repeatedly press
8 8 8 8
or
9 9 9 9
to select the talk group
ID list location (shown at the top of the display) you
want to delete.
3. Press 0 then E .
Priority Talk Group ID Scanning
You can assign a priority to a favorite ID so during scan-
ning the scanner checks that ID more frequently than the
others in the list. Each of the five memory locations re-
20-524A.fm Page 50 Tuesday, June 27, 2000 3:41 PM