Radio Shack PRO-94 - Manual (Page 56)

56 Trunking Operation
Note: If you select size code S-12, S-13, or S-14, these
restrictions apply:
• S-12 can only be assigned to Blocks 0, 2, 4, or 6
• S-13 can only be assigned to Blocks 0 and 4
• S-14 can only be assigned to Block 0
Since these size codes require multiple blocks, you will
be prompted for the next available block when you pro-
gram a fleet map. For example, if you assign Block 0 as
S-12, the scanner prompts you for
b2 , the next block
available, instead of b1. If you assign Block 0 as S-14,
you would not see another prompt because S-14 uses
all available blocks.
Programming the Base and
Offset Frequencies
To properly track Motorola VHF and UHF trunked sys-
tems, you must program the applicable
base and offset
frequencies for each system.
For a list of these frequencies and other scanner infor-
mation, go to www.trunkscanner.com and other similar
frequency resources.
1. Set the scanner for conventional scanning. Press
PROG then TRUNK .
2. Press the number key of the bank where you want
to store the base frequency.
3. Repeatedly press
8 8 8 8
or
9 9 9 9
to select E2-VHi or
E2-UHF , then press E . A previously programmed
trunked frequency appears.
4. Press DATA (ALT) . The preset base frequency
appears.
5. Enter a desired frequency.
6. Press DATA (ALT) . The preset offset frequency
appears.
20-524A.fm Page 56 Tuesday, June 27, 2000 3:41 PM