GIGABYTE GA-MA790FXT-UD5P - Manual (Page 49)

- 49 - BIOS Setup
2-6 Integrated Peripherals
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Integrated Peripherals
OnChip IDE Channel [Enabled]
OnChip SATA Type [Native IDE]
x OnChip SATA Port4/5 Type IDE
Onboard SATA/IDE Device [Enabled]
Onboard SATA/IDE Ctrl Mode [IDE]
 Smart Backup [Press Enter]
Onboard Audio Function [Enabled]
 Onboard LAN device [Press Enter]
Onboard 1394 Function [Enabled]
OnChip USB Controller [Enabled]
USB EHCI Controller [Enabled]
USB Keyboard Support [Disabled]
USB Mouse Support [Disabled]
Legacy USB storage detect [Enabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
x ECP Mode Use DMA 3
: Move
Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
OnChip IDE Channel
Enables or disables the integrated IDE controller. (Default: Enabled)
OnChip SATA Type (AMD SB750 South Bridge, SATA2_0~SATA2_3 connectors)
Configures the operating mode of the integrated SATA2_0~SATA2_3 controller.
Native IDE Allows the SATA controller to operate in Native IDE mode. (Default)
Enable Native IDE mode if you wish to install operating systems that
support Native mode.
RAID Enables RAID for the SATA controller.
AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller
Interface (AHCI) is an interface specification that allows the storage driver to
enable advanced Serial ATA features such as Native Command Queuing
and hot plug.
OnChip SATA Port4/5 Type (SATA2_4/SATA2_5 connectors)
This option is configurable only when OnChip SATA Type is set to RAID or AHCI. Configures the
operating mode of the integrated SATA2_4/SATA2_5 connectors.
IDE Disables RAID for the SATA controller and configures the SATA controller to
PATA mode. (Default)
As SATA Type The mode depends on the OnChip SATA Type settings.
Onboard SATA/IDE Device (GIGABYTE SATA2 Chip, GSATA2_0~3 connectors)
Enables or disables the SATA controller integrated in the GIGABYTE SATA 2 chip. (Default:
Enabled)
Onboard SATA/IDE Ctrl Mode (GIGABYTE SATA2 Chip, GSATA2_0~3 connectors)
Allows you to decide whether to configure the SATA controller to AHCI mode.
IDE Configures the SATA controller to PATA mode. (Default)
AHCI Configures the SATA controller to AHCI mode.