Smart backup – GIGABYTE GA-MA790FXT-UD5P User Manual

Page 50

Advertising
background image

GA-MA790FXT-UD5P Motherboard

- 50 -

Controller 0 (GSATA2 0/1)/ Controller 1 (GSATA2 2/3)

CMOS Setup Utility-Copyright (C) 1984-2009 Award Software

Controller 0 (GSATA2 0/1)

Item Help

Menu Level

Disk/RAID Status

[Press Enter]

Smart Backup Config

[Press Enter]

: Move

Enter: Select

+/-/PU/PD: Value

F10: Save

ESC: Exit

F1: General Help

F5: Previous Values

F6: Fail-Safe Defaults

F7: Optimized Defaults

The Controller 0 (GSATA2 0/1)/Controller 1 (GSATA2 2/3) submenu allows you to check the
information of the hard drive(s) connected to the GSATA2_0~3 connectors or to configure a RAID array.
The Controller 0 (GSATA2 0/1) supports the GSATA2_0 and GSATA2_1 connectors and the Control-
ler 1 (GSATA2 2/3)
supports the GSATA2_2 and GSATA2_3 connectors. After the configuration, ensure
the SATA controller driver has been installed in the operating system. You can install the Smart Backup
utility (refer to Chapter 5, "Configuring SATA Hard Drive(s)," to view the device status in the operating
system.

Smart Backup

CMOS Setup Utility-Copyright (C) 1984-2009 Award Software

Smart Backup

Item Help

Menu Level

Controller 0 (GSATA2 0/1)

[Press Enter]

Controller 1 (GSATA2 2/3)

[Press Enter]

: Move

Enter: Select

+/-/PU/PD: Value

F10: Save

ESC: Exit

F1: General Help

F5: Previous Values

F6: Fail-Safe Defaults

F7: Optimized Defaults

Note: In case you need to set this item to AHCI mode and want to install Windows XP onto the AHCI
hard drive, you have to install the SATA controller driver during the OS installation. Refer to Chapter
5, "Configuring SATA Hard Drive(s)," for how to make a driver diskette and install the driver.

Advertising