GIGABYTE GA-MA790FXT-UD5P User Manual

Page 88

Advertising
background image

GA-MA790FXT-UD5P Motherboard

- 88 -

Figure 2

Step 4:
After configuring the SATA ports, you are ready to proceed with the installation of the operating system.
You do not have to load the SATA controller driver during the installation process of the operating
system. Make sure to install the driver after the operating system is installed (using "Xpress Install" to
install all drivers required for your motherboard is recommended) for the SATA hard drives to work and
be detected properly.

Step 5:
Then install the Smart Backup utility from the Application Software menu on the driver Autorun screen
for monitoring the device/RAID status in the operating system (for more information, refer to section 5-
1-5, "Smart Backup Utility").

CMOS Setup Utility-Copyright (C) 1984-2009 Award Software

Smart Backup Config

Item Help

Menu Level

Smart Backup Config

[Performance (RAID 0)]

Apply RAID Config

[Press Enter]

=== Disk Info ===
[Port] [Model]

[Capacity]

Port 0

WDCWD800JD-00JNA0

80GB

Port 1

WDCWD800JD-22LSA0

80GB

=== RAID Info ===
[Level] [Capacity] [Member]
Performance 0GB

: Move

Enter: Select

+/-/PU/PD: Value

F10: Save

ESC: Exit

F1: General Help

F5: Previous Values

F6: Fail-Safe Defaults

F7: Optimized Defaults

Advertising