Radio Shack CID 940 - Manual (Page 12)

12 Preparation
3. Plug a third line cord into the answering machine’s phone
jack and the telephone’s modular jack.
4. Set your answering machine to answer after two or more
rings. This gives the system time to record the call informa-
tion that the phone company sends between the first and
second rings.
SETTING THE SYSTEM’S
IDENTIFICATION CODE
You can install multiple receivers. Each receiver that you install
must be set with the same identification code as the transmitter.
Follow these steps to set the code.
Note: If you hold down PAGE for 5 seconds or longer, the trans-
mitter’s identification code changes. Be sure to set all receivers
to the new code.
1. Place the receiver next to the transmitter.
2. Hold down SET on the receiver for about 5 seconds.
WAITING ID appears.
3. Press PAGE on the transmitter within 10 seconds after
WAITING ID appears. This sends the transmitter identifi-
cation code to the receiver. The receiver beeps and ID
SET appears, indicating that the ID code is set.
CHECKING THE RANGE
1. Place the receiver at the desired location.
2. Press PAGE on the transmitter.
43-940.fm Page 12 Tuesday, April 25, 2000 1:04 PM