Radio Shack CID 940 - Manual (Page 13)

13 Preparation
If the receiver is within the range, it beeps and PAGED
appears for 30 seconds.
If PAGED does not appear, move the receiver closer to the
transmitter and press PAGE again. If it still does not beep,
repeat the steps under “Setting the System’s Identification
Code” on Page 12 to verify that the identification code is
properly set.
The receiver checks the range every three hours. If the receiver
is out of the range of the transmitter,
OUT OF RANGE appears.
Move the receiver closer to the transmitter and press PAGE to
check the range again.
Note: The transmitter can support an unlimited number of re-
ceivers. The distance between receivers should be 2 feet or
more to avoid interference.
SETTING THE DISPLAY CONTRAST, ALERT
TONE, AND CLOCK DISPLAY FORMAT
1. Hold down SET and
9 9 9 9
DOWN for about 5 seconds until
SETTINGS appears.
2. Press
9 9 9 9
DOWN to set the display contrast (the default set-
ting is 2).
3. Repeatedly press SET to select the contrast level (1–4),
then press
9 9 9 9
DOWN . The current tone setting appears.
(The default setting is BEEP OFF .)
4. Press SET to toggle between BEEP ON and BEEP OFF ,
then press
9 9 9 9
DOWN . The display shows the current clock
format setting (the default setting is a 12-hour format).
43-940.fm Page 13 Tuesday, April 25, 2000 1:04 PM