8 paper feed specifications, 1 paper feed methods/paths, 2 paper positioning restrictions – Oki POS 425S User Manual
Page 88: 3 paper tear-off, 4 paper end detection
88
OKIPOS 425S
|
5.8 Paper Feed Specifications
5.8.1 Paper feed methods/Paths
a
Friction feed
For Cut-sheet paper
b
Friction feed
For Roll paper
c
Push tractor feed (Front path)
For Sprocket paper (Tractor)
5.8.2 Paper Positioning Restrictions
OP425_31.eps
1
Cut-sheet paper (slip)
2
Roll paper
3
Sprocket paper (Tractor)
4
Printing position on the first line
5
Printing position on the last line
6
Cut-sheet paper (Counterfoil, Stub)
5.8.3 Paper Tear-off
Roll paper
The paper can be torn off 41.69mm (1.64 inch) above the first printed line. A sharp serrated edge is provided on the top
cover for paper tear-off.
Sprocket paper (Tractor)
The paper can be torn off 35.96mm (1.42 inch) above the first printed line. A sharp serrated edge is provided on the access
cover for paper tear-off.
5.8.4 Paper End Detection
1
With cut-sheet paper feed, the paper end is detected when the remaining paper length is about 19.6mm (0.77 inch) from
the last printed line.
2
With roll paper feed, the paper end is detected when the remaining paper length is about 87.83mm (3.46 inch) from the last
printed line.
3
With Sprocket paper (Tractor) feed, the paper end is detected when the remaining paper length is about 19.6mm (0.77
inch) from the last printed line.
4
Upon detecting the paper end, the printer stops printing and sends a paper end signal to the interface.
1
2
3
4
5
6