OmniTek TOPAZ 839-1340 - Manual (Page 34)

34 Quadra-Fire • Topaz • 7009-113 Rev. N • 5/13
NOTE: This blower utilizes a snap disc to control ON and
OFF operation. When the correct temperature is reached,
the blower will automatically turn ON. Use the rheostat knob
to adjust the fan to High or Low to suit your preferences.
Figure 8.29 Install speed control to switch panel. Attach knob
to speed control.
Figure 8.30 Reinstall rear shield. Connect blower to power
supply and turn on gas supply.
J. Blower Installation
FROM THE KIT YOU WILL NEED: Blower motor; snap
disc bracket with wire harness; rheostat, rheostat nut; knob;
screws; 1 zip-tie.
Figure 8.26 Turn off gas supply, (if gas is connected,) and
remove rear shield. Remove blower from packaging. Place
blower under appliance. Attach blower from front with 4
screws to blower bracket.
Figure 8.27 Install snap disc in bracket. Attach bracket to fi re-
box with 5/16 in. wrench.
Figure 8.28 Connect electrical connector to snap disc.
TOOLS REQUIRED: #2 Phillips head bit; hand drill; 11/16
in. wrench; and a 5/16 in. wrench.
Attach with 4
screws
Snap Disc
Bracket
5/16" nut
I. Glass Door Assembly Replacement
Remove the glass door assembly by opening latches at the
bottom front of the appliance, on both the left and right sides.
Lift out and away from the appliance.
Replace with a new glass door assembly.
Handle glass assembly with care.
CAUTION
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door
removed, cracked, broken or scratched.
• Replace glass assembly as a complete
assembly.