Omega Engineering DP3300 Series - Manual (Page 17)

DP3300 Series User’s Manual
Page16
SET UP
Voltage or Current Setup Thermocouple / RTD / Thermister Setup
Select Channel
Turn Ch On/Off
Select Input Type
Turn Ch On/Off
Select Input Type
Enter
Decimal Point
Enter Tare
Enter Process Limits
(1 thru 3)
Enter Relay Deadband
Prog. Relay Latching/
Non Latching
Prog. Engineering Units
Select Relays Normally
Open /Normally Closed
(Limits 1thru 3)
Enter Rate Time Base
Enter Process Limits
(1 thru 3)
Enter Relay Deadband
Prog. Relay Latching/
Non Latching
Prog. Engineering Units
Select Relays Normally
Open /Normally Closed
(Limits 1thru 3)
Enter Rate Time Base
Select Display Option
1.Scan
2.High point
3.Low point
4.CH 1 – CH 2
5.CH 2 – CH 1
6.Elapsed Time
Enter Display Time
Select Audio alarm On/Off
Calibrate Cold Junction
Channel Calibration
Enter Voltage Range
Enter Current Range
Select Display Units
Degree C/F
FLOW CHART FOR ANALOG INPUT
Enter Low Scale
Enter Off Set
SYSTEM OR CHANNEL
SYSTEM SETUP CHANNEL SETUP
Enter High Scale