Omega Engineering DP3300 Series - Manual (Page 19)

DP3300 Series User’s Manual
Page18
SETUP FOR A PULSE CHANNEL:
Turning a Channel ON or OFF
The very first thing after selecting a channel is to turn it on or off. A channel should be turned off if it is not being used. Use ^v
key to select the desired setting. If a channel is OFF, the display will show 'CHx OFF' (where ‘x’ is the channel number) and
if it is ON the display is 'CHx ON'. Use ^v key to display the desired ON/OFF setting, and then push SETUP key to go to the
next parameter.
MODES OF OPERATION FOR A PULSE INPUT CHANNEL:
A pulse Channel can operate in any one of the following modes:
MODE DISPLAY SHOWS DESCRIPTION
Counter Mode COUntEr For a Channel being configured as a counter.
Rate Mode rAtE For a Channel being configured as a rate monitor.
RPM mode SyS rP For a Channel being configured as RPM monitor.
High Frequency Mode HI FrEq For a Channel being configured as high frequency meter.
Low Frequency Mode LO FrEq For a Channel being configured as low frequency meter.
To change operating mode of the system push ^v key. After obtaining the desired mode, push SETUP key.
The next function to be configured depends on the operating mode selected above. To configure for different modes, look under
appropriate headings.
SETUP FOR COUNTER:
If a channel is setup as a counter, then the following steps have to performed. To abort at any point during the setup, push RESET
key once to get to the very beginning of SETUP, or push and hold (till SAVING is displayed) to get out of SETUP altogether.
FUNCTION DISPLAY SHOWS TO CHANGE
Counter mode 0 Cntr 0 Push ^v key till
Counter mode 1 Cntr 1 desired mode is
Counter mode 2 Cntr 2 selected .
Counter mode 3 Cntr 3
Counter mode 4 Cntr 4
Counter mode 5 Cntr 5
Preset value entry
'PrESEt' followed by preset Push ^v key to increment or decrement
value e.g. 10.024 with active digit. Push <NXT> key to change
active digit flashing. active digit.
Relay Delay entry
'dELAY' followed by preset Push ^v key to increment or decrement
value e.g. 24 with active active digit. Push <NXT> key to change
digit flashing. active digit.
Decimal point
dP 9999 Push ^v key to
placement dP 999.9 move decimal
dP 99.99 point to desired
dP 9.999 position.
Scaler
'SCALER' followed by preset Push ^v key to increment or decrement
Scaler value e.g. 0.00024 with active digit. Push <NXT> key to change