Flow chart for pulse input, Set up – Omega Engineering DP3300 Series User Manual
Page 18
DP3300 Series User’s Manual
Page17
SET UP
Select System or Channel Programming
For System Programing Refer to
Flow Chart for Analog Input
SELECT INPUT TYPE
1. Voltage 2. Current 3. J T/C
4. K T/C 5. T T/C 6. E T/C
7. Pulse
Turn CH On/Off
Low Freq.
High Freq.
RPM
Counter
Rate
Enter Rate Time
Base
Select Filter
Value
Select Counter
Mode
0,1,2,3,4,5
Enter Preset Value
Enter delay
Select Dec.Pt
Position
Scaler
Division Factor
Enter Limits
(1 thru 3)
Deadband
RelayLatching/
Non- Latching
Select Limits
Normally Open /
Normally closed
(Limits 1thru 3)
Enter Rate TimeBase
Select Dec.Pt
Position
Scaler
Division Factor
Enter Limits
(1 thru 3)
Deadband
RelayLatching/
Non- Latching
Select Limits
Normally Open /
Normally closed
(Limits 1 thru 3)
Scaler
Division Factor
Enter Limits
(1 thru 3)
Deadband
RelayLatching/
Non- Latching
Select Limits
Normally Open /
Normally closed
(Limits 1 thru 3)
Scaler
Division Factor
Enter Limits
(1 thru 3)
Deadband
RelayLatching/
Non- Latching
Select Limits
Normally Open /
Normally closed
(Limits 1 thru 3)
Select Dec.Pt
Position
Scaler
Division Factor
Enter Limits
(1 thru 3)
Deadband
RelayLatching/
Non- Latching
Select Limits
Normally Open /
Normally closed
(Limits 1 thru 3)
Enter Rate Time
Base
FLOW CHART FOR PULSE INPUT: