Omega Engineering DP3300 Series - Manual (Page 25)

DP3300 Series User’s Manual
Page24
MOUNTING
3.70” (94mm)
4.05 ” (10 2.87 mm)
1.77”
(45mm)
0.15” dia. (3.81mm)
Figure 4. Panel Cutout Dimensions
1. Cut out Panel and mounting hole dimensions as shown in figure 8 above.
2. Remove the nuts from the mounting screws on the Panel Meter (see picture below).
3. Insert panel meter into the hole until it is flush with the panel.
Install the nuts and tighten them till the unit is held firmly against the panel.
1. Remove nuts and insert Panel
Meter and screws in mounting holes
in the panel cut out.
2. Tighten the nuts, after mounting
the unit in the panel cut out, till the
unit is held firmly against the panel.