Onkyo TX-DS484 - Manual (Page 15)

15
Speaker setup
4. Press the PARAMETER SELECTOR® button to display
the center speaker size parameter, and press the PARAME-
TER CONTROLLER √/® buttons to select “LARGE”,
“SMALL” and “NONE.”
Note:
If you have selected “SMALL” for the front speakers, you can
select only “SMALL” or “NONE” for the center speaker.
LARGE: When a large speaker is used as the center speaker.
SMALL: When a small speaker is used as the center speaker.
NONE: A center speaker is not connected.
5. Press the PARAMETER SELECTOR® button to display
the surround speaker size parameter, and press the
PARAMETER CONTROLLER √/® buttons to select
“LARGE”, “SMALL” and “NONE.”
Note:
If you have selected “SMALL” for the front speaker, you can
select only “SMALL” or “NONE” for the surround speakers.
LARGE: When large speakers are used as the surround
speaker.
SMALL: When small speakers are used as the surround
speaker.
NONE: Surround speakers are not connected.
6. Press the PARAMETER SELECTOR® button to display
the front speaker position parameter, and press the
PARAMETER CONTROLLER √/® button repeatedly to
set the distance value from your listening position to the
front speaker.
Pressing the PARAMETER CONTROLLER® button repeatedly
increases the value.
Pressing the √PARAMETER CONTROLLER button repeat-
edly decreases the value.
Set the value closest to the actual distance.
7. Press the PARAMETER SELECTOR® button to display
the center speaker position parameter, and press the
PARAMETER CONTROLLER √/® buttons to set the
center speaker position parameter.
•
If you have selected “NONE” for the center speaker in step 4,
you cannot set this parameter.
You cannot set the following values:
•
Values larger than the front speaker position setting
•
Values smaller than the value obtained by subtracting “5ft”
from the front speaker setting
8. Press the PARAMETER SELECTOR® button to display
the surround speaker position parameter, and press the
PARAMETER CONTROLLER √/® buttons to set the sur-
round speaker position parameter.
•
If you have selected “NONE” for the surround speakers in
step 5, you cannot set this parameter.
You cannot set the following values:
•
Values larger than the front speaker position setting
•
Values smaller than the value obtained by subtracting “15ft”
from the front speaker setting
PARAMETER SELECTOR
PARAMETER CONTROLLER
f t
f t
or
PARAMETER SELECTOR
PARAMETER CONTROLLER
f t
f t
or
PARAMETER SELECTOR
PARAMETER CONTROLLER
f t
f t
PARAMETER SELECTOR
PARAMETER CONTROLLER
PARAMETER SELECTOR
PARAMETER CONTROLLER
6
7
8
4
or
5
or
or
or
meter feet