Selecting a sound source, Press multi ch input button on the remote contr, Press the ch sel button to select the desired s – Onkyo TX-DS484 User Manual
Page 18: Use the level ¹/† button to change the volume l, Use the volume control to set the desired level, Press the parameter selector ã or ® button 2. r, Press the parameter controller ã or ® button to
18
Selecting a sound source
Follow the steps below to adjust the level of each speaker if you
have selected MULTI CH INPUT.
1. Press MULTI CH INPUT button on the remote controller.
You cannot select any Surround mode.
2. Press the CH SEL button to select the desired speakers.
3. Use the LEVEL π/† button to change the volume level of
the speakers.
You can adjust the volume level of each speaker individually. Adjust
the level while listening to the sound in the listening position.
You can adjust the level of the front, center, and surround speak-
ers in the range between –12dB and +12dB.
You can adjust the subwoofer level in the range between –30dB
and +12dB.
Note
•
If the speaker level is set to +1dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
This function automatically selects the volume level you set last
time.
Follow the steps below:
1. Use the VOLUME control to set the desired level.
2. Press the PARAMETER SELECTOR √ or ® button
repeatedly to display the “PWR ON VOL” parameter.
The current setting (ON or OFF) appears.
3. Press the PARAMETER CONTROLLER √ or ® button to
select “ON.”
Even if the parameter has already been set to ON, turn it OFF,
then turn it ON again to enable the Power On Volume function.
The original display appears and the setting is completed. When
you turn on the power to the unit next time, it will use the vol-
ume level you set in step 1.
Note:
If the PWR ON VOL parameter is set to OFF, the Power On Vol-
ume function is disabled. In this case, when you turn on the power
to the unit next time, it will use the volume level that was set when
you turned off the power.
When Multi channel input is selected as a source
Using the Power On Volume function
PARAMETER CONTROLLER
PARAMETER SELECTOR
2
3
1
U
P
MASTER VOLUME
D
O
W
N
PARAMETER CONTROLLER
PARAMETER SELECTOR
1
2
MULTI-CH
INPUT
POWER
SLEEP
DIMMER
SUR
MODE
VIDEO-1 VIDEO-2
TAPE
DVD
C D
C D
DVD
TUNER
TUNER
PHONO
INPUT SELECTOR
DISC
TAPE
VOLUME
LEVEL
CH SEL
PRESET
MUTING
TEST
TONE
MULTI-CH
INPUT
REMOTE CONTROLLER
RC-427S
LEVEL
CH SEL
TEST
TONE
POWER
SLEEP
DIMMER
SUR
MODE
VIDEO-1 VIDEO-2
TAPE
DVD
C D
C D
DVD
TUNER
TUNER
PHONO
INPUT SELECTOR
DISC
TAPE
VOLUME
LEVEL
CH SEL
PRESET
MUTING
TEST
TONE
MULTI-CH
INPUT
REMOTE CONTROLLER
RC-427S
LEFT
L-SUR
CENTER
RIGHT
R-SUR
SUBWOOFER