Onkyo TX-DS484 - Manual (Page 7)

7
REMOTE CONTROL
CD
AM
FM
75
ANTENNA
GND
PHONO
R
L
R L
(PLAY)
(REC)
OUT
I N
MONI-
TOR
OUT
SUB
WOOFER
PRE OUT
SURROUND
2 1
FRONT
R R
A
B
L L
R L
TAPE
VIDEO 1
CENTER
SUB
WOOFER
R L V
VIDEO 2
DVD
CENTER R L
DIGITAL INPUT
FRONT SPEAKERS
R L
SPEAKER
CENTER
SPEAKERS
SURROUND
COAXIAL COAXIAL OPTICAL
MULT I CH I NPUT
OUT
I N
I N
I N
TX-DS484
AC OUTLETS
AC 230V 50Hz
SWITCHED TOTAL 100W MAX.
DVD Player
Monitor TV
Video Cassette Recorder
VIDEO IN
AUDIO IN VIDEO IN
AUDIO OUT VIDEO OUT
AUDIO OUTPUT
DIGITAL COAXIAL OUTPUT VIDEO OUTPUT
DIGITAL OPTICAL OUTPUT
: signal flow
L (Left)
R (Right)
L
R
V (Video) V
Audio connection cable
Video connection cable
Digital audio connections
This receiver has a powerful digital signal
processor for use with DVD players, DAT
decks, MD player, and CD players. The digi-
tal inputs, COAXIAL 1, 2 and OPTICAL can
be assigned to individual input selector but-
tons, so when an input selector button is
pressed, the assigned digital input is used
instead of the corresponding analog input. (See
page 19.)
Video equipment connections
•
On each pair of input jacks, a red connector (marked R) corresponds to the right
channel, and a white connector (marked L) to the left channel.
•
A yellow connector (marked V) is used for video connection.
•
Please refer to the instruction manual of each component when making any con-
nections.
Notes:
•
When using a playback-only VCR, you need to make only the output connections.
•
This receiver can be used with only a monitor TV equipped with a video input jack.
•
Interference may be caused between the TV and this receiver. If this interference occurs, place the receiver and the TV as far apart
as possible. We do not recommend the use of a common TV/FM antenna (see antenna section).
•
A DVD or other component equipped with a digital output can be connected to this receiver. The digital connection must be used in
conjunction with an analog connection, because if the analog cable is disconnected, the audio output from TAPE OUT and VIDEO 2
will not work.
•
Remove the protective cap attached to the DIGITAL INPUT OPTICAL jack before making the connection. When this jack is not
used, replace the protective cap.