Odyssey Electronics Marine GPS System - Manual (Page 17)

Aiming Beam
The Odyssey Navigator diode laser is actually two lasers in one, the infrared 810 nm wavelength laser which
performs the actual treatment of the soft tissue, the “working beam” and the 650 nm “laser pointer” which
illuminates the focal point of the “working beam” allowing the operator to aim prior to and during laser
activation. In addition, the aiming beam control allows for five levels of illumination ranging from off to
maximum intensity. The open circle indicates no aiming beam and the solid blue circle indicates the brightest
aiming beam.
To adjust aiming beam intensity, the bar is depressed which activates the above screen, Fig 3.1.13g. The arrows
are depressed upward or downward as desried. Each increment adjusts the aiming beam intensity by 20%. When
complete, depress the “Done” key to return to the setting screen. Check if the new settings meet your desired
aiming beam intensity, Fig 3.1.13h.
Ready Indicator
This illuminates when the READY key is pressed. It will blink for 3 seconds, then remain
steady. Once steady, the aiming beam will be activated and the laser is ready to be fired.
Laser On
This illuminates when the foot pedal is depressed, indicatingthat the working beam
(810nm) energy is being emitted.
Favorites
Any combination of settings can be easily saved for convenience
with a user defined name. Press the button “Save as Favorite” in
the lower right corner of the touch screen when you are in Quick
Set Up Mode or in on one of the Specialty Procedure Screens.
Confirm “yes” on the next pop-up window (Fig 3.1.13i) and
enter a descriptive name by pressing the respective
buttons until you have the next letter in the box in the upper
right corner of your screen. Either confirm this letter by touching
it in the upper right corner or press another button or wait more than 2 seconds before
pressing the same button. As a result this letter will be transferred to the name field in the
middle of the dark grey portion of the upper screen (Fig 3.1.13j). It is possible to delete
one character at a time by pressing “Clear”. Note: Only lower case letters possible.
Press “Save” after the name is complete and confirm with “OK” (Fig 3.1.13k) to save your
entry in a special non-transient memory for future use.
Favorites can be easily deleted by choosing a particular favorite setting from the
“Favorites” menu and by pressing “Delete Favorite” and confirming with “Yes” in a second step.
17
Navigator
3 W AT T D I O D E L A S E R
O D Y S S E Y
TM
®
LASER ASSEMBLY INSTRUCTIONS
Section 3
Fig 3.1.13h
Fig 3.1.13g
No aiming beam Maximum aiming beam power
Fig 3.1.13i Fig 3.1.13j
Fig 3.1.13k