Olympus MAUSB-100 - Manual (Page 10)

10
128
MB
1 Inserting a card
<98/98 SE
ࡗOperation>
1. Make sure that the hold switch is released, then insert a card into the MAUSB-100's card slot.
Make sure the card is level and that the gold-colored contact area is facing down. Insert the card all the way
into the slot.
2. Lock the hold switch.
Operating the MAUSB-100
The operating procedures for the MAUSB-100 under Windows 98/98 SE are described below.
MAUSB-100
Card slot
Status lamps
Inserting the card
xD-Picture Card
128
MB
2 Setting the write-protect switch
<98/98 SE
ࡗOperation>
Before connecting the MAUSB-100 to your computer, set the write-protect switch to ON or OFF as required.
ON : When you want to protect data stored on the
inserted card from being deleted by mistake.
The stored data cannot be changed, moved
or deleted from the card, and the card cannot
be written to or formatted.
OFF : When you want to change, move or delete
the data stored on the inserted card, or want
to write to or format the card.
Note
If you have important data stored on the card, set the write-protect switch to ON to prevent accidental deletion.
Notes
• Make sure that the card is facing the right way.
• Do NOT insert the card at an angle. Forcing a card in diagonally may damage the card and/or the
MAUSB-100.
• Be sure to lock the hold switch after inserting the card. The computer will not be able to recognize the
card if the hold switch is released.
ON OFF
Hold switch