Olympus MAUSB-100 - Manual (Page 18)

18
How to install
You do not need to install the utility software to use the MAUSB-100.
Also refer to your computer’s user manual and the manuals for any optional devices you are using.
1 Turn on the computer
<Me/2000/XP
ࡗInstall>
Turn on your computer’s power (and connected devices) to start Windows Me/2000/XP.
If you are using a Windows 2000/XP, log on with the user name [Administrator], or use a user name with
administrator privileges.
2 Install the utility software
<Me/2000/XP
ࡗInstall>
Before using the MAUSB-100 for the first time, it is recommended to install the utility software included on the
provided CD-ROM.
● The device driver will not be installed with this procedure; it is not necessary for Windows Me/2000/XP since
it is recognized as an OS-standard device driver.
Windows Me/2000/XP
Before installation, make sure that the computer is turned on, then follow the steps below to install the utility
software on your computer.
● Note that the windows shown below may look different on your computer, depending on how your operating
system is configured.
1. Turn on the computer, then place the provided
CD-ROM into the computer’s CD-ROM drive.
2. When the CD-ROM is recognized, the
InstallShield setup window is displayed for a few
seconds. Then, the [InstallShield Wizard] window
appears.
3. Click the [Next] button.
● If the window at right does not appear, refer to
“If the installation window does not appear
when the CD-ROM is loaded” (
੬
p. 20).
● If you want to cancel the installation, click
[Cancel].