Olympus MAUSB-100 - Manual (Page 24)

24
4 Removing a card
<Me/2000/XP
ࡗOperation>
Close all software programs that are using data on the card (e.g. Explorer, graphics applications), then
follow the steps below.
Attention!
● If you do not follow the steps below, the data on the card may be damaged.
● Do not apply force to the computer's USB port or the MAUSB-100 when removing/inserting a card from/
into the MAUSB-100 if it is directly connected to the computer's USB port.
1. Double-click [My Computer] on the desktop.
2. Right-click the corresponding [Removable
Disk] icon, then click [Eject] in the pop-up
menu.
● The card will not be ejected when [Eject] is clicked
in this step.
3. Make sure that the red status lamp is NOT on.
4. Release the hold switch, then pull the card out
of the card slot as shown.
● If you are using a Windows 2000/XP, you can only
remove a card under the user name [Administrator]
or a user name with administrator privileges. Log
on with the correct user name and password if you
want to remove the card.
Note
• NEVER release the hold switch, remove the card or disconnect the MAUSB-100 from the computer while
the red status lamp is lit. Doing so may destroy the data on the card or the card itself, or cause the
computer to malfunction.
• Be careful when removing the card as it can get hot after extended use. Take special care not to touch the
card’s terminals.
128
MB
128
MB
Status lamps
1 Release the hold switch
2 Remove the card