Olympus MAUSB-100 - Manual (Page 9)

9
1. Double-click [My Computer].
<98/98 SE
ࡗInstall>
2. Right-click [OLYMPUS]. Select [Open] from the
pop-up menu.
4. Double-click [Setup.exe].
● The [InstallShield Wizard] window appears. Start
installing by following “2 Install the device driver/
utility software” (
੬
p. 7).
1. Disconnect the MAUSB-100 from the computer
(
੬
p. 13).
2. Click the [Cancel] button.
3. Place the CD-ROM into the CD-ROM drive.
Follow the instructions in “2 Install the device
driver/utility software” (
੬
p. 7).
If the installation window does not appear when the CD-ROM is loaded
Follow the steps below to specify the file and start installing.
When the [Add New Hardware Wizard] window appears
If you connect the MAUSB-100 to the computer
before installing the device driver and utility
software, the [Add New Hardware Wizard] window
appears. In this case, follow the steps below.
3. Double-click [MAUSB_100].