Oki S900 - Manual (Page 72)

APPENDIX D – SETTING UP > 72
As part of the warm-up message, the Scancopier LCD display shows
the installed Firmware version number and the Color Table version
number.
At the end of the warm-up message, the LCD display shows the
system default values in readiness for copying.
SETTING UP ADDITIONAL SETTINGS
Since the factory default settings for the S900 may not match your
particular application, you can set up your own defaults by using the
Additional Settings button in conjunction with the adjacent Arrow
Keys. Having made your own settings, use the Save Settings button to
save them as the new user default settings. To return to the original
factory default settings, hold down the All Clear button for 5 seconds.
When you press the Additional Settings button, the following menu
and factory default settings appear in the LCD display:
0. PIN Setting: Enable
1. Printer Profile: OKI C9500
2. Media Type: Plain Paper
3. Duplex: OFF
4. Staple: OFF
5. Hole Punch: OFF
6. Output Tray: Top Output (Face down)
7. Multi-Purpose Tray: ON
8. Collate: ON
9. Paper Tray: Tray1
10. Power Saving Mode: 30Min.
NOTE
The default installed Color Table is for the C9500 printer. To set up your
Scancopier for use with a C9300 printer, use the Additional Settings
button as described in the following section.