Playback to tv wall – Optiview G0521 User Manual
Page 15
DVR Server Manual ver.5.05/rel.092507
11
12. Play back to TV monitor
In DVR system, the recording data can be transmitted to TV monitor via Matrix card.
When system runs the
―Playback to TV Wall‖ process, the Matrix card will output recording data.
If this process does not run, matrix decode card will output real-time video according to your
. Otherwise, when you use matrix card to decode video data from IP Camera, you
can‘t
use this function to play back recording video data to TV Monitor but only output real-time video of
local board and IP Camera to TV Wall according to you setting in
. In this process, you
can play back record file by date and camera, and the record file will be played automatically.
13. Motion Detect setup
By default, the entire screen is set as motion detection area where it is indicated with green
border around the image. To have a specific area for motion detection, you can click
button
to cancel the full screen detection border; then Left-Single-Click and drag a rectangle. A green
rectangle will mark the area. The DVR will now detect motion only in the area inside the green
border line. You can set as many areas as you want. Any activities in the motion detection areas
(meaning any motion inside the green border line) will trigger recording, depending on the reaction
mode and alarms that may be generated along with electronic map icons flashing in alert mode or
whatever settings you have set on the DVR configuration. Click
button to test the
sensitivity of motion detection. The sensitivity can be adjusted by dragging the slider bar below the
motion detection window.
Notice: motion sensitivity value will affect the accuracy of