Optiview G0521 - Manual (Page 35)

DVR Server Manual ver.5.05/rel.092507
31
2.4 PTZ & Linkage setup
2.4.1 PTZ protocol setup
【Selected Camera】Select the camera from the drop-down list to set the parameters. The
cameras just include the cameras of local board card; IP Cameras are not included. For IP Camera,
you should set it remotely in IP Camera setup .
【PTZ Port】 Select PTZ connecting port, when you do not use PTZ port, please choose ―------‖.
【PTZ Protocol】Selects the PTZ protocol for the PTZ camera.
【PTZ Address】Set the camera ID number of the PTZ camera being controlled.
Note: The PTZ camera has a dip switch to set the PTZ address. The PTZ camera ID number must
match the number of this dip switch. The actual Dip switch settings from the PTZ camera must
match the settings on this PTZ menu, otherwise the PTZ will not be able to communicate properly
thereby it would fail to pan, tilt or zoom. PTZ configuration changes on this menu will not change the
actual PTZ dip switch settings on the PTZ camera.
【PTZ Baud rate】Select PTZ Baud rate for the PTZ camera.
【PTZ Position】 Select the installation mode of the PTZ according to its installation mode.
Notes:
1. PTZ position will influence PTZ control. E.g.: if you set it as obverse and press left, then it will turn
left. If you set it as inverse and press left, then it will turn right.
2. If there is (H) after the PTZ protocol, it has the high speed of Preset function. If there is no (H), it
only has ordinary functions.
3. The PTZ address will be sent as a message option. Take care that some address begins from 0.
That is to say，when the address number is 1, the real address is 0. So we must set it according to
their relations.