Omega Speaker Systems OMEGAFLEX FPU5-MT-220 - Manual (Page 53)

6.4 The TOTAL VOLUME Mode
Figure 6-7 shows the overall block diagram of the TOTAL VOLUME Mode in
the RUNNING Display Mode.
Figure 6-7. Block Diagram: Pumping in the TOTAL VOLUME Mode
In the TOTAL VOLUME Mode, you pump a specific quantity of fluid at a
certain motor speed or flow rate. The pump motor uses the RPM or FLOW
RATE setting. It measures the time of pumping but ignores the TIME setting.
STOPPED
DISPLAY
MODE
OR
START
STOP
RUNNING
DISPLAY
MODE
CALCULATED
VOLUME
DISPENSED
CURRENT
TOTAL VOLUME
SETTING
TOTAL VOLUME
SETTING TO BE
USED IN PUMPING
START
STOP
(Stop before
Total Volume is
Dispensed)
(Total Volume is Dispensed)
TOTAL
VOLUME
OR
TUBE ID SETTING
TO BE USED IN
PUMPING
OR
CURRENT
TUBE ID
SETTING
CURRENT
RPM
SETTING
OR
FLOW
RATE
CURRENT
FLOW RATE
SETTING
FLOW RATE
SETTING
TO BE USED IN
PUMPING
CALIBRATE
TUBE ID
RPM SETTING TO BE
USED IN PUMPING CALIBRATE RPM
(Refer to Section 5.5)
(Refer to Section 5.5)
(Optional)
(Optional)
6-16
Operating the Pump Motor in the RUNNING Display Mode 6