Oricom SECURE 200 - Manual (Page 11)

9 BASIC OpERATION
Once you have set up your Baby Monitor, you will be able
to hear the sounds in your baby's room through the Parent
Unit. And also see the green and red sensor lights around
the top of the Parent Unit rise and fall with the sound levels.
Note:
If the connection between the Parent and Baby Units is
broken at any time the green Link light on the Parent Unit
will flash slowly, the parent unit will beep to alter you that
the link has been lost and the green and red sensor lights
will cease to react to any sounds. Move closer to the baby
unit or follow the directions in "Troubleshooting" chapter to
re-establish the link.
Power On/Off
Once connected to the power supply,
• Press [ ] on each Unit to turn on the power.
• To switch off, press and hold the [ ].
Monitoring
• Position the baby unit accordingly. It should be
placed 1 metre to 1.5 metres away from the baby's
cot on a flat surface.
• Take the parent unit to monitor.
• Audio picked up by the baby unit microphone is
depicted on the 8 lights on the parent unit (5 green
and 3 red). The more audio is picked up, the more
lights will be lit. When no audio is picked up, all 8
lights will be off.
• If the volume of the Parent Unit is turned off, an alert
will sound when the audio reaches the second red
led.
Note:
Do not position the baby unit and the parent unit close to
each other as feedback may be generated.
Adjusting Volume
You can adjust the volume at which you hear your baby.
There are 5 volume levels on both units and an Off setting
on the parent unit.
On the parent unit
Press [ ] to increase the volume and [ ] to decrease
the volume.
On the baby unit
Press [ ] to increase the volume and [ ] to decrease
the volume.
When adjusting the volume, the volume level will be
displayed on the both units LCD display.