Oki POS 425D - Manual (Page 74)

74 OKIPOS 425D
|
2 Counterfoil and Stub
OP425_11.eps
1 Printing area
2 Stub
3 Inserting direction
A25023.doc
Symbol Designation Standard Value
W Paper width 70mm (2.76 inch) or more
L Paper length 40mm (1.57 inch) or more
A Print starting position 18mm (0.7 inch) or less
B Left margin 2.54mm (0.1 inch) or more
C Right margin 2.54mm (0.1 inch)
D Printing area width Max 160.02mm (6.3 inch)
Note 1 To feed paper, insert a paper from the top side of the device and keep holding it until printing ends.
Note 2 Use a flat sheet free curls, bends (especially those on its edges), cambers, wrinkles, etc. If a sheet is not flat, it may
be contaminated with ink due to ink ribbon contact.
Note 3 Before printing on a stub, fold the other sheets backward to make the stub available for print as shown in the fig.
below.
OP425_12.eps
1 Fold backward
2 Stub
1
2
3
1
2