Olympus FL-36 - Manual (Page 11)

21 20
PICTURE SHOOTING USING A DIGITAL CAMERA WITH COMMUNICATION CAPABILITY
<Selecting the control mode>
1. Turn the camera on.
2. Turn the electronic flash on. The batteries are recharged
when the Charge lamp lights up.
3. Press the Shutter button of the camera gently to start com-
munication of shooting information including ISO speed,
lens iris and shutter speed between the camera and elec-
tronic flash.
4. Press the MODE button of the electronic flash to select
the flash control mode.
• The selected flash control mode is shown in the control
panel.
• The mode is switched every time the MODE button is
pressed.
Usually use this mode with a
camera with communication
capability.
Flash control
mode
TTL AUTO
AUTO
MANUAL
FP
TTL AUTO
FP
MANUAL
22
24
27
29 & 32
Control panel
display Control operation Main application Ref.
Pages
Flash is controlled automatically
by performing pre-flash accord-
ing to the camera setup.
Flash light intensity is controlled
according to the light detected
through the auto light receptor of
the flash and to the camera setup. If the camera has communica-
tion capability, this mode can be
used only when the camera is
an AUTO-compatible model.
Flash is performed according to
the manually set guide number
(GN). Shooting using manual flash.
TTL AUTO and MANUAL modes
with Super FP emission that can
synchronize with the high-speed
shooting of the single-lens-reflex
focal plane shutter. Outdoor shooting using flash,
such as sync shooting in the
daytime.
Notes
• Certain modes may be unavailable depending on the shooting mode set on the camera and the functions of the
camera in use.
• It is not possible to select an unavailable mode.
Flash
control mode