Olympus FL-36 User Manual
Page 18
35
34
Lens iris (F)
<AUTO>
ISO speed
In this mode, the flash light intensity is controlled automatically according to the lens iris (F) setting.
PICTURE SHOOTING USING A DIGITAL CAMERA WITHOUT COMMUNICATION CAPABILITY
1.
Turn the electronic flash on. The batteries are recharged
when the Charge lamp lights up.
2.
Press the MODE button to select the flash control mode.
• The selected mode is shown in the control panel.
• The mode is switched every time the MODE button is
pressed.
<Selecting the control mode>
Flash light intensity is controlled
according to the light detected
through the auto light receptor of
the flash and to the lens iris (F).
AUTO
MANUAL
35
37
Usually use this mode.
Flash activation is performed
according to the manually set
guide number (GN).
Flash control
mode
Control panel
display
Control operation
Main application
Ref.
Pages
Shooting using manual flash.
Memo:
By selecting an ISO speed and lens iris (F) different from those
set on the camera, the light intensity can be adjusted in 1/3 steps.
Memo:
Test flash activation
Flash activation can be tested before actually releasing the shutter.
Press the Test button for test flash activation.
The light control is OK when the AUTO CHECK lamp blinks for about 5 seconds after
the test flash activation.
If the lamp does not blink, change the lens iris (F), ISO speed, subject distance, etc.
• The light check by means of test flash activation is possible only in the AUTO mode.
AUTO indicator MZOOM indicator
1.
Adjust Zoom according to the focal length of the lens.
2.
While keeping the MODE button pressed, turn the select dial within
2 seconds to set the ISO speed.
Note: If the MODE button is kept pressed for more than 2 seconds,
the flash mode changes to the Custom Setup mode (see page 47).
3.
Turn the select dial according to the lens iris (F).
If the camera setup (ISO speed and lens iris (F)) does not
match one of the usable ISO speed/lens iris (F) combina-
tions, the ISO and F indicators blink to alert you. In this case,
change the camera setup (ISO speed and/or lens iris (F)).
4.
When flash activation has been performed correctly,
the AUTO CHECK lamp blinks for about 5 seconds
after the shutter is released.