Oki RT322POS - Manual (Page 44)

– 40 –
(3) ESC/POS mode
Switch Function ON OFF
1-1 Command emulation Always OFF
1-2 Command emulation Always OFF
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment Invalid Valid
1-5 Should not be changed (Should be set to on)
1-6 Handshaking conditions
(conditions for BUSY)
Offline or receive
buffer full
Receive buffer full
1-7 ASB function *1 Invalid Valid
1-8 Should not be changed (Should be set to on)
1-9 Graphic adjustment 203 DPI 180 DPI
1-10 Should not be changed (Should be set to on)
*1 ASB Function
When this function is enabled, status information is automatically sent to the host whenever the
printer status changes (such as when the cover is opened, paper runs out, or an error occurs).
For information about automatic status information transmission, refer to the separate Program-
mer's Technical Reference manual (Star Line Mode, Star Page Mode, and ESC/POS Mode).
DIP-SW 2
Switch Function ON OFF
2-1
Always ON Should be set to on
2-2
2-3
2-4
The factory settings of DIP switch are all on.