2. rs-232c connector – Oki RT322POS User Manual
Page 53
– 49 –
12-2. RS-232C Connector
Pin No.
Signal name
Direction
Function
1
F-GND
—
Frame ground
2
TXD
OUT
Transmission data
3
RXD
IN
Receive data
4
RTS
OUT
Same as DTR
5
N/C
Not used.
6
DSR
IN
1) Star Mode
Not used.
2) ESC/POS Mode
When DIP Switch 3-7 = OFF;
A) DTR communication mode
Indicates whether data receive from host is enabled or
disabled.
Space: Receive enabled
Mark: Receive disabled
(except when transmitting data by DLE EOT, and GS a)
B) X-ON/X-OFF communication mode
Status of this signal is not checked.
When DIP Switch 3-7 = ON;
This is an externally reset signal.
A space above 1 ms pulse width engages reset.
7
S-GND
—
Signal ground
8~19
N/C
Not used.
20
DTR
OUT
1) Star Mode
A) DTR communication mode
Indicates whether data receive from host is enabled
or disabled.
Space: Receive enabled
Mark: Receive disabled
B) X-ON/X-OFF communication mode
Always space, except during following conditions:
• Period between reset and communication enabled
• During self printing