Oki B 6500 - Manual (Page 47)

B6500 Network Guide> 47
S
WITCHING THE
P
OWER
O
N
/O
FF
Take note of the following when switching off the printer:
Printer Spooling Is Set to [On] Spool Mode
All the spooled print data, including print data which is being printed,
will be saved. When the power is switched on again, the stored print
data will be printed first even if new print data has been instructed.
Printer Spooling Is Set to [Off] Nonspool Mode
All the print data spooled in the printer receive buffer, including print
data which is being output, will be deleted. When the printer is
switched on again, the print data will not be found.
However, if the power is switched off immediately after the print
data has been sent, the data may be stored on the computer. In this
case, when the power is switched on again, the stored print data will
be printed first even if new print data has been sent.
P
RINTING
F
ROM
W
INDOWS
Take note of the following when printing from Windows:
• In the spool mode, if the print data is bigger than the
remaining capacity of the hard disk or the memory at the
point of receiving, the data will not be received by the printer.
NOTE
> Some client computers may re-send immediately when
the print data has exceeded the receiving capacity. When
this occurs, the client appears as if it has crashed. To
rectify this situation, the client computer must be stopped
from sending print data.
> In the non-spool mode, printing will commence once data
starts to be received by the printer. Therefore, if the
printer has accepted a print request from a computer, it
will not receive another print request from another
computer.
> For PCL and DUMP, the specification for the number of
copies is invalid.