Omega 3200ST - Manual (Page 4)

M-4271/0707, pg. 4 of 26
A. Introduction
1. Unpacking
All units are suitably packaged to prevent damage during shipping. If
external damage is noted upon receipt of the package, please contact
Omega Engineering immediately.
Open the package from the top, taking care not to cut too deeply into the
package. Remove all the documentation and contents. Take care to
remove all the items and check them against the packing slip. The
products should also be checked for any concealed shipping damage. If
any shortages or damage is noted, please contact Omega Engineering to
resolve the problem.
Typical Contents of Box: Controller, Calibration Certificate & Manual
FMA 3200/3200ST shown; FMA 3400/3400ST have an integrated display.
Caution: Take care not to drop your controller. Read the
installation section of this manual before providing power or
tubing connections to the unit. Any damage caused by improper
installation or careless handling will not be repaired under
warranty (see limited warranty on page 25 for more details).
2. Product Overview and Principle of Operation
The FMA 3200/3400 Series Mass Flow Controllers from Omega
Engineering
are capable of measuring and controlling the flow of virtually
any clean, dry gas as low as 0-20 sccm or as high as 0-10 l/min.
Repeatable results are achieved using a patented thermal mass flow