Oki C710n - Manual (Page 16)

16 – C710n User’s Guide
4. Adjust the rear stopper (a) and paper guides (b) to the size
of paper being used.
To prevent paper jams:
• Do not leave space between the paper and the guides and
rear stopper.
• Do not overfill the paper tray. Capacity depends on the
type of paper stock.
• Do not load damaged paper.
• Do not load paper of different sizes or types at the same
time.
• Do not pull the paper tray out during printing (except as
described below for the 2nd tray).
• Close the paper tray gently.
• If you have two trays and you are printing from the 1st
(upper) tray, you can pull out the 2nd (lower) tray during
printing to reload it. However, if you are printing from the
2nd (lower) tray, do not pull out the 1st (upper) tray. This
will cause a paper jam.
• For face down printing, make sure the face up (rear)
stacker (a) is closed (the paper exits from the top of the
printer). Stacking capacity is approximately 350 sheets of
20-lb. US Bond (75 g/m
2 ) paper.
• For face up printing, make sure the face up (rear)
stacker (a) is open and the paper support (b) is extended.
Paper is stacked in reverse order and tray capacity is
approximately 100 sheets of 20-lb. US Bond (75 g/m
2 )
paper.
CAUTION!
IMPORTANT: Set paper size dial (c) to the size of
paper being used (A4 in the above example).