Oki C710n - Manual (Page 85)

85 – C710n User’s Guide
10. Holding the complete assembly by its top centre, lower it into
place in the printer, locating the pegs at each end into their
slots in the sides of the printer cavity.
11. Finally, close the top cover and press down firmly at both
sides so that the cover latches closed.
Replacing the Transfer Belt Unit ____
The belt unit is located under the four image drums. This unit
requires replacement approximately every 60,000 pages.
Switch off the printer and allow the fuser to cool for about
10 minutes before opening the cover.
Note:
If you need to return or transport your printer for any
reason, please make sure you remove the image drum
unit beforehand and place in the bag provided. This is to
avoid toner spillage.