Oki C710n - Manual (Page 39)

39 – C710n User’s Guide
Print
Setup
(cont.)
PS Setup X
Dimension 64 mm
~
210 mm
~
216 mm Specifies paper width of
Custom paper as a default
value.
Sets a paper size at right angles
to the paper run direction.
Y
Dimension 127 mm
~
297 mm
~
1220 mm Specifies paper length of
Custom paper as a default
value.
Sets a paper size in the same
direction as the paper run
direction.
Network
Protocol
ASCII/RAW Specifies PS communication
protocol mode of data from NIC
port.
(In RAW mode, Ctrl-T is
invalid). PS models only.
Parallel
Protocol
ASCII/RAW Specifies PS communication
protocol mode of data from
Centronics port.
(In RAW mode, Ctrl-T is
invalid). PS models only.
USB
Protocol
ASCII/RAW Specifies PS communication
protocol mode of data from USB
port.
(In RAW mode, Ctrl-T is
invalid). PS models only.
PCL
Setup Font
Source Resident Specifies the location of PCL
default font.
Font
Number I0 ~ I90 Sets the PCL font number.
The valid range of this variable
changes depending on the
FONT SOURCE setting at the
time. If the default font is set
for FONT SOURCE, the number
starts at 0. If it is not, the
number starts at 1. The
maximum value is equal to the
number of fonts installed in
FONT SOURCE.
ITEM SETTINGS EXPLANATION