Omega OMA-P1104 User Manual
Omegaphone, Oma-p1104
Advertising
Table of contents
Document Outline
- Table of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Introduction
- Chapter 2: Installation
- 2.1 Operating Environment
- 2.2 Mounting
- 2.3 Power Surge Protection
- 2.4 Power Supply and Battery Backup
- 2.5 Starting the OMA-P1104
- 2.6 Run Mode and Standby Mode
- 2.7 Telephone Line
- 2.8 The Microphone
- 2.9 Alert Inputs
- 2.10 Installing the Sensor
- 2.11 Multiple Sensors
- 2.12 Outdoor Wiring
- 2.13 Disconnecting for Storage or Seasonal Use.
- Chapter 3: Quick Start
- Chapter 4: Communications Programming
- 4.1 The Unit ID Number
- 4.2 Dial-out Telephone Numbers
- 4.3 Tone or Pulse Dialing
- 4.4 Special Dialing
- 4.5 Rings Until Answer
- 4.6 TAD (Telephone Answering Device)
- 4.7 Listen-in Time
- 4.8 Call Delay
- 4.9 Local Voice Mute
- 4.10 Voice Repetitions
- 4.11 Intercall Time
- 4.12 Maximum Number of Calls (Max Calls)
- 4.13 The Clock
- 4.14 The Security Code
- Chapter 5: Alarm Programming
- 5.1 Input Configuration
- 5.2 Enable/Disable Inputs
- 5.3 Input Recognition Time
- 5.4 Establishing High and Low Temperature Limits
- 5.5 Temperature Scale
- 5.6 Temperature Calibration
- 5.7 Obtaining Current Temperature
- 5.8 AC Power Monitoring Enable/Disable
- 5.9 AC Power Failure Recognition Time
- 5.10 Sound Alarm Monitoring
- 5.11 High Sound Alarm Enable/Disable
- 5.12 Exit Delay
- Chapter 6: Acknowledgment, Status Report, and Remote Access
- Appendix A: Troubleshooting
- Appendix B: Accessories 87