Omega Vehicle Security PTC900 - Manual (Page 15)

15
When active (maintained action), the meter “holds” (maintains) the present
output state for all Setpoints entered as in the sublist. Does not apply to
Output Set and Reset User Inputs. Program only one user input for this function.
Note: The remaining parameters only appear when a Setpoint Card is
installed in the meter.
ª
«
ª
«
OUTPUT HOLD (Level Active)
NO Setpoint 4 SP-4
NO Setpoint 3 SP-3
NO Setpoint 2 SP-2
NO Setpoint 1 SP-1
FACTORY DESCRIPTION DISPLAY
ª
«
ª
«
OUTPUT SET (Level Active)
When activated (maintained action), the meter continually activates the
output for all Setpoints entered as in the sublist.
NO Setpoint 4 SP-4
NO Setpoint 3 SP-3
NO Setpoint 2 SP-2
NO Setpoint 1 SP-1
FACTORY DESCRIPTION DISPLAY
When activated (momentary action), the meter activates the output for all
Setpoints entered as in the sublist.
ª
«
ª
«
OUTPUT SET (Edge Triggered)
NO Setpoint 4 SP-4
NO Setpoint 3 SP-3
NO Setpoint 2 SP-2
NO Setpoint 1 SP-1
FACTORY DESCRIPTION DISPLAY
When activated (maintained action), the meter continually deactivates the
output for all Setpoints entered as in the sublist.
ª
«
ª
«
OUTPUT RESET (Level Active)
NO Setpoint 4 SP-4
NO Setpoint 3 SP-3
NO Setpoint 2 SP-2
NO Setpoint 1 SP-1
FACTORY DESCRIPTION DISPLAY
When activated (momentary action), the meter deactivates the output for all
Setpoints entered as in the sublist.
ª
«
ª
«
OUTPUT RESET (Edge Triggered)
NO Setpoint 4 SP-4
NO Setpoint 3 SP-3
NO Setpoint 2 SP-2
NO Setpoint 1 SP-1
FACTORY DESCRIPTION DISPLAY
When activated (momentary action), the display intensity changes to the next
intensity level (of 4). The four levels correspond to Display Intensity Level
(
) settings of 0, 3, 8 & 15. The intensity level, when changed via the User
Input/Function Key, is not retained at power-down, unless Quick Programming
or Full Programming mode is entered and exited. The unit will power-up at the
last saved intensity level.
ª
«
ª
«
CHANGE DISPLAY INTENSITY LEVEL
Note: The next two parameters only appear when an RS232 or RS485 Serial
Communications Card is installed in the meter.
When activated, the meter issues a block print through the serial port. The
specific values transmitted during a print request are selected with the Print
Options parameter in Module 7. For User Inputs (level active), the meter
transmits blocks repeatedly as long as the input is active. For Function Keys,
(edge triggered) only one block is transmitted per key press.
ª
«
ª
«
PRINT REQUEST
ª
«
ª
«
PRINT REQUEST and RESET (Edge Triggered)
When activated (momentary action), the meter first issues a block print
through the serial port, and then performs a Momentary Reset on the displays
entered as
in the sublist. The specific values transmitted in the print block
are selected with the Print Options parameter in Module 7. Only one transmit
and reset occurs per User Input activation or Function Key press.
NO Cycle Counter C-dSP
NO Timer t-dSp
FACTORY DESCRIPTION DISPLAY