Orion 2xx - Manual (Page 8)

5 46-649 Jupiter Magnetostrictive Transmitter - F OUNDATION fieldbus™
2.3 Before You Begin
Caution: This instrument is intended for use in Installation
Category II, Pollution Degree 2 locations.
2.3.1 Site Preparation
Each Jupiter magnetostrictive transmitter is built to match
the specifications required within the defined model
option number. Wiring terminations will need to be made
and the configuration will need to be accomplished.
Ensure that the power to be supplied to the instrument is
the same voltage (24 VDC) as ordered with the instru-
ment, and that the wiring between the power supply and
the Jupiter transmitter is correct for the type of installa-
tion. See Specifications, Section 5.3.
NOTE: Applying incorrect voltage will damage the unit.
When installing the Jupiter transmitter in a general
purpose or hazardous area, all local, state, and federal
regulations and guidelines must be observed. See Wiring,
Section 2.5.
2.3.2 Equipment and Tools
For installation of a new Jupiter with magnetic level indi-
cator set, refer to Orion Instruments instruction manual
46-638.
To attach a Jupiter transmitter to an existing MLI or direct
insertion model, you may need the following tools:
• 5 ⁄
16
" Nut-Driver (for tightening the mounting clamps).
• Screwdriver and assorted hand tools for making conduit
and electrical connections.
• Digital multimeter or DVM to troubleshoot supply
voltage problems.